Covcheg
Covcheg Valorant: installation and launch guide
This page walks you through preparing the system for Covcheg Valorant, starting the loader from a USB drive and reaching the point where the function menu is open and the in-game status reads READY. It also covers the two issues players run into most often.
Read this first
- Once the software is loaded and the game is running, give it 3–5 minutes in the main menu until the indicator in the top left switches to READY. Do not queue for a match before that.
- Physically unplug the USB flash drive when the loader asks for it — only then press OK.
- Do not judge ESP by the shooting range: bots there are not displayed.
Before you start
- Watch the injection walkthrough — Injection video: https://youtu.be/aWfDRDPYVuE
- Reach out through Discord or Telegram if you need product support.
- Get the loader and the key — both are handed over once the purchase is complete.
Launch steps
Prepare Overwolf and Arkbuddy first, then run the loader from a removable drive.
- Install Overwolf from https://www.overwolf.com/
- Open the Overwolf app library, locate Arkbuddy, install it and start it.
- Go to Overwolf settings → Overlay & Hotkeys and turn the in-game overlay off for Valorant, following the supplier's guide.
- Shut the game down completely. A PC restart before every session is advised.
- Plug in a USB flash drive and unpack the archive folder onto it.
- Start loader.exe, type in the key you received with your purchase and confirm with Enter.
- Pull the flash drive out of the port when the loader asks you to eject it, then press OK.
- Wait for the prompt "Open Arkbuddy Crosshair and Press F5": switch to Arkbuddy, hit "Toggle Crosshair", make sure the crosshair actually appears on screen, then press F5 and give the product menu a moment to load.
- Start the game once the function menu has opened. To close the cheat, use F10 the way the menu describes.
Troubleshooting
Two situations account for most reports.
- ESP draws nothing during a match: skip the shooting range, since bots are not rendered there — check it in an actual match instead. Then look at Windows Security → Memory integrity (HVCI) and switch it according to the supplier's recommendation.
- Initialization drags on and the status stays yellow: restart the PC, and let the initialization finish inside a match rather than sitting in the menu only.
FAQ
Why do I need Overwolf and Arkbuddy at all?
The loader relies on Arkbuddy at one point in the sequence: it asks you to open the crosshair and press F5. Arkbuddy is installed from the Overwolf app library, so Overwolf has to be on the PC first. Just remember to disable the in-game overlay for Valorant in Overlay & Hotkeys before you run the loader.
When is it safe to join a match?
Only after the status in the upper-left corner changes to READY. Load the software, start the game and stay in the main menu for roughly 3–5 minutes while it finishes.
The loader asks me to eject the flash drive. Do I really have to unplug it?
Yes. Take the drive out of the USB port physically, and press OK afterwards, not before.
How do I shut the cheat down?
Press F10. The function menu describes the shutdown procedure, so follow what it shows.
ESP is not drawing enemies even though the menu works. What now?
First make sure you are testing in a real match — the shooting range will not show bots. If the problem persists there, open Windows Security, find Memory integrity (HVCI) and toggle it as the supplier advises.
Initialization takes forever and the status stays yellow.
Reboot the computer and try again. It also helps to let the initialization complete while you are inside a match instead of waiting in the menu.